If problems with handsets are encountered on an older release, or on a configuration originally generated on an older release, upgrade to a current version of pfSense or manually adjust the outbound NAT rules. Select ‘Manual outbound NAT rule generation` Click Save & Apply configuration; A number of rules will be created automatically. Apply Changes nicht vergessen! ... Outbound NAT. As suggested you can either use 1:1 NAT and have access-lists allowing access to only the required ports or a static outbound NAT rule. 1 - Log in to your pfSense Web Interface and navigate to Firewall / Aliases and click on Add. My only Package is Darkstat. Es wird nicht immer dien Angabe des Subnetzes in den Regeln benötigt und sollte das sich mal ändern, reicht es dann den Alias zu ändern.Im Menü bei Firewall – Aliases – IP Name: LOKALNET Type: Network(s) Network or FQDN: 192.168.1.0 / 24 und mit Save abspeichern. Zunächst müssen virtuelle IP-Adressen erstellt werden, damit pfSense sich für diese überhaupt angesprochen fühlt: Am Web-Interface anmelden. (Öffentliche) IP-Adressen bekannt machen. I shutdown the Xbox, rebooted pfsense, once pfsense was good, checked the Xbox and it was Open. I have "autoconfigured" the outbound NAT from pfSense.

If I tried to ping any of the statics I was getting TTL timeout issues however if say I add a 1:1 NAT on an entry with firewall rules to allow traffic ping then works fine.
Essentially any host behind the NAT gateway sends it’s outbound requests to the gateway, which forwards that traffic to its destination and keeps track of which private host made the request, when a response comes back the gateway forwards that back to the original host. Firewall Optimization - Conservative¶ System -> Advanced -> Firewall NAT -> Firewall Optimization. The problem I mentioned above still persists, but only when editing an outbound NAT rule in the destination network field. Go to Firewall >> NAT >> Outbound (! With all this setup, I can't connect to any remote address. 3) Ich hab den Artikel mal um meine FritzBox Einstellungen erweitert. select Conservative. ... First we will create an alias to use in the firewall rule. Outbound NAT does not control which interface traffic will leave, only how traffic is handled as it exits. Host alias for the PBX itself, named PBX, containing the local IP address of the PBX. I'm asking someones time to look at my issue and maybe deducing the problem. Edit ‘localhost to WAN’ NAT. To control which interface traffic will exit, use :doc:`policy routing ` or :doc:`Static Routes `. After that it worked! Now when I was having this issue, Xbox over and over kept saying Strict. Also, So your outbound rule looks like this (Besides your set alias) Before I start to play around I thought I'd ask the Networking Gurus on STH if there's more to consider / something I may have missed or don't understand completely. I've tested port forwarding off one of the IP's and that works, I've tried Outbound NAT and that also works. So idecided to create an alias for 4 internal IPs and did outbound NAT. ; Network or Host alias called SIP_Trunks for the upstream SIP trunk addresses, if known.